No terminal server license

To switch to the telephone activation option, right-click the server in Terminal Services License Manager, and then click Properties. Skip to main content. This browser is no longer supported. Download Microsoft Edge More info. Contents Exit focus mode.

Please rate your experience Yes No. Any additional feedback? Note After you move the CALs, you must deactivate the old license server. See step In this article. The configuration of the licenses should resemble the following screenshot. There should be a green check mark beside the license server name, and the numbers in the columns should reflect the numbers of total and available licenses. The RDS deployment uses the correct license server, licensing mode, and policy settings.

The details of the configuration depend on the type of deployment that you have:. In the policy list, right-click Use the specified Remote Desktop license servers , and then select Properties. Select Enabled , and then enter the name of the license server under License servers to use. If you have more than one license server, use commas to separate their names.

In the policy list, right-click Set the Remote Desktop licensing mode , and then select Properties. Follow this section's instructions carefully. Serious problems can occur if the registry is modified incorrectly. Before you starty modifying the registry, back up the registry so you can restore it in case something goes wrong. To resolve this problem, back up and then remove the X Certificate registry keys, restart the computer, and then reactivate the RD Licensing server.

Follow these steps. It is possible to have more than seven JETx. TMP files. If the server is powered off without using the shutdown routine or if the server is shut down inside an RDP client session, the JETx. TMP files are not cleaned up. Shutting down the server through an RDP client session is generally not an issue, since services are written to handle power outages by committing cached data very quickly.

Administrators should be aware, however, that the normal shutdown procedures are not followed. If you shut down the server at the console, all services are stopped before the server shuts down. The server shuts down immediately, without stopping services correctly if the shutdown is performed through a client session.

Because services are not notified, the JETx. TMP files will already exist when the server is restarted. If JETx. TMP files numbered exist, the server will create new files numbered If you deleted files which could be done since they would not be open and shutdown the system through the RDP client again, the new files created at startup would again be numbered So, the highest numbered files are not necessarily the files that are in use. If left over JETx.

Only the closed, unused files will be deleted.