Electronic Accessory Fax Machine Hair Clippers Headphones Hole Punch 4. Home Audio Home Theater System Household Appliance Integrated Telephone System Microwave Oven Personal Care Portable Radio Portable Stereo System Print Board Projection Television Projector Recording Equipment Remote Control Rice Cooker Security Camera Solar Panels 3. Speakerphone Telephone System Packages 3.
System Upgrades 4. Telephones 5. Activation Keys 7. KX-TD 8. Technical Support 9. Refurbished Equipment Installation Equipment Headsets Music-On-Hold Special Needs Products Paging Equipment Page 2. A surge protector is a device that is connected to a CO line to prevent potentially dangerous electrical surges from entering the building via the CO line and damaging the PBX and connected equipment.
If you install an extension outside of the building, the following precautions are recommended: Install the extension wire underground. Use a conduit to protect the wire. Page 52 2. The grounding wire should be as short as possible.
The grounding wire should run straight to the ground rod. Page Cid4 Card 2. To be mounted on the LCOT4 card. Page Plc4 Card 2. Page Slc8 Card 2. Page Plc8 Card 2. Page 60 2. A pair of "sensor" and "common" lines must be connected to the DPH4 card for each external sensor. Page Msg2 Card 2. Page Ext-Cid Card 2. Page Rmt Card 2. ITU-T V. Push the card firmly into place until you hear a clicking sound. Page 66 2. Page Connection Of 2. Up to 2 calls can be made at the same time through each CS. PS: 2.
Page Procedure Overview 2. Inadvertent site survey can result in poor service area, frequent noise, and disconnection of calls. Investigate the installation site Refer to "2. Page 71 4. Finish the site survey Refer to "2. Turn off the PS. Page Site Planning 2.
The best location may not always be convenient for installation. Read the following information before installing the unit. Understanding the Radio Waves Characteristics of Radio Waves The transmission of radio waves and the CS coverage area depend on the structure and materials of the Page 74 2.
Note Radio signal strength levels are measured during the site survey refer to "2. Gray Zone: Conversation will be intermittent Page 75 one CS becomes weak. If the signal from the CS fades, due to the structure of the building, there may be some handover delay.
Page Before Site Survey 2. Set the CS number switches as desired. CS no. Do not connect the AC adaptor to a ceiling-mounted AC outlet, as the weight of the adaptor may cause it to become disconnected. Then, record the results on the map of the installation site. Page 79 Measure the radio signal strength by moving to and away from the CS.
Move to the CS until the point the radio signal strength level becomes "12". Move away from the CS and identify the CS coverage area within which the radio signal strength level is greater than "8".
Page 80 2. Page After Site Survey 2. Disconnect the AC adaptor or battery box from the CS and stop supplying electricity. Page 84 2. An APT with multiline display e. Note For details about system programming using an APT, refer to "2. Page 86 2. You do not need to enter the PS system programming mode when registering for the first time. Page 88 2. Page Wall Mounting 2. Install the 2 screws and washers included into the wall.
Page 90 2. Page 92 2. Please choose the appropriate kind for your wall type. Page 93 2.
0コメント